Washing Cycle - Ata Alp 40 Installations-, Gebrauchs- Und Wartungsanleitung

With reference to picture 1, the appliance is switched on by pushing the main switch (B); at the
same time the warning lamp (C) lights on.
The appliance automatically fills water into the tank up to the set level and it switches on the boiler
and tank heating elements. The boiler thermometer (A) will show the achieved temperature.
When the right temperature is achieved, the lamp (H) lights on, so to show that the appliance is
ready for starting the washing cycle.
N.B. The internal thermostats are set by the manufacturer at the following temperatures:
 boiler water temperature: 78 °C;
 tank water temperature: 55 °C.
N.B. If the selector (D) is pushed during the washing cycle, the water temperature in the tank is to
be seen on the display (A). When the selector (D) is released, the water temperature in the boiler is
to be seen again on the display.

WASHING CYCLE

 Open the door of the appliance and pour some detergent into the tank (except for versions with
built-in detergent dispenser). The tank capacity is of 20 litres; therefore, the detergent shall be
poured into according to its manufacturer's prescriptions.
 Remove all the solid remainders from the dishes and put them inside the baskets.
 Slide the basket into the appliance and shut its door.
 Select the washing cycle.
 When switched on, the appliance automatically sets itself to work according to the short
washing cycle, suitable for washing glasses or not very dirty dishes. This cycle is shown by
the lighting of the lamp (E).
 In order to select the long washing cycle, push the selector (D); this operation is shown by
the turning off of the lamp (E) and the lighting of the lamp (F).
 In order to select the short washing cycle, push again selector (D); this operation is shown by
the turning off of the lamp (F) and by the lighting of the lamp (E).
 It is not possible to pass from short to long washing cycle or vice versa if the washing cycle
has already started.
 Push the start switch (G) and the lamp (I) lights on: the appliance automatically starts the
washing and then the rinsing cycle, starting also the rinse aid dispenser. Between the washing
and the rinsing cycle the appliance makes a dripping pause. When the cycle is finished, the lamp
(I) turns off.
 On demand, it is available a device called "THERMOLOCK", which lengthens the washing
cycle until when the water in the boiler achieves the pre-set right temperature. The operation is
shown by the blinking of the lamp (I).
 Any cycle phase can be stopped simply by pushing the selector (G). If it is pushed again, the
working cycle starts from the beginning.
 In order to start the following cycle, repeat all the operations, considering that the detergent has
to be added every 3 – 4 washing cycles.
 To switch off the appliance, make sure that it has finished its working cycle and then push the
main switch (B). This operation is shown by the turning off of the lamp (C).
18