Preliminary Steps - Ata Alp 40 Installations-, Gebrauchs- Und Wartungsanleitung

 400 V (3N) 50 Hz
 230 V (3) 50 Hz
The manufacturer's arrangement matches the first specification; the second one can be achieved
following the provided wiring diagram. In particular, as for the washing pump, in order to pass to
230 V three-phased, simply interpose the spacing block between the pump connector and the wiring
connector. The spacing block is always supplied with the model ALP 40 and it is placed near the
cables of the washing pump, fixed with a clamp.
WARNING: While electrically connecting appliances working with 3-phase alternating current,
check the rotating direction of the pump motor.
WARNING: We highly recommend that the appliance is properly earthed.
The manufacturer assumes no liability for damage resulting from not observing this safety rule.
The manufacturer also assumes no liability for damage resulting from faulty electric connection.
USE

PRELIMINARY STEPS

Before starting the appliance, perform the following operations.
 Check that the filling and draining hoses supplied with the appliance are connected to the water
mains.
 The appliance is provided with a rinse aid dispenser and, on request, also with a detergent
dispenser, which are already set during the testing of the appliances by the manufacturer.
Connect the dispensers to their respective tanks, containing chemicals, which have necessarily to
be low-viscosity fluids; otherwise the dispensers may obstruct or break. Use only detergents
suitable for commercial dishwashers. Totally avoid foaming products.
 If present, check the right positioning of the detergent probe, because using the dispenser dry can
damage or break the device.
 Check the right positioning of the pump intake filter and of the surface filter.
 Check that the overflow pipe is in its right place.
 Close the door of the appliance, open the water cock and check the electric feeding.
WATER FILLING AND HEATING
A Boiler / tank thermometer
B Main switch
Warning lamp "machine on"
C
D Selector short / long cycle
Warning lamp "short cycle"
E
Warning lamp "long cycle"
F
G Start switch
Warning lamp "machine ready"
H
Warning lamp "cycle on"
I
Picture 1
17