Troubleshooting List - Aesculap Suhl Favorita II Gebrauchsanweisung

Aesculap Suhl GmbH
Shearing machine Favorita II, Favorita Speed, Electra® II, Ehmann turbo-line®
7.

Troubleshooting list

Issue
Shearing head not mov-
ing
Device cutting poorly or
not at all
Device motor not run-
ning
Device motor running
very slowly
8
Detection
Shearing head jammed
Device not cutting
Cutting performance
insufficient
Strong heat-up of shear-
ing head
Shearing head jammed
Device not cutting
Smell of burning from
the machine housing
Shearing head jammed
Atypical motor noises
Cause
Shearing head not prop-
erly engaged in its seat-
ing
Rocker arm defective
Cutting edges of shearing
head blunted
Animal hair too wet
Shearing head lacking
shearing pressure
Cutting edges of shearing
head not honed correctly
Lack of lubrication of
shearing head edges
Animal hear jammed in
shearing head
Debris on electric con-
tacts
Motor/Electronics defec-
tive
Motor burnt
Debris in shearing head
Lack of lubrication of
shearing head edges
Remedy
Properly engage the shear-
ing head, see section
Attaching the Blade
Replace rocker arm
Have product repaired by
the manufacturer
Only cut dry animal hair
Have product repaired by
the manufacturer
Have product repaired by
the manufacturer
Lubricate cutting edges of
shearing head, see section
Lubricating the shearing
head
Demount shearing head and
remove animal hair
Switch off device and clean
the contacts
Have product repaired by
the manufacturer
Have product repaired by
the manufacturer
Clean and lubricate the
shearing head, see section
Lubricating the shearing
head
Lubricate cutting edges of
shearing head, see section
Lubricating the shearing
head