For Your Safety; Delivery Contents; Assembly And Disassembly - Aventics HF03 LG Montageanleitung

AVENTICS | HF03 LG/HF04/Stand-Alone-System | R499050014–BAL–001–AE | English
English
1 About this document
These instructions contain important information for the
safe and appropriate assembly of the following
components on a DIN rail EN 50 022 35x15:
W
Valve terminal system (VS) HF03 LG
W
Valve terminal system (VS) HF04
W
Stand-Alone system
These components are termed systems in the following.
O Read these instructions before working with the
systems.
O Keep these instructions in a location where they are
accessible to all users at all times.
O Observe the safety instructions and warnings.
Structure of the safety instructions
Type and source of risk
Consequences
O Precautions
Meaning of signal word
This signal word indicates a potentially hazardous
situation which, if not avoided, could result in minor or
moderate injury or damage to the equipment.
Related documents
W
Operating instructions for the systems
W
Technical data and information in accordance with the
online catalog
(www.aventics.com/pneumatics-catalog)
2

For your safety

Intended use
Only use the mounting kit for the DIN rail to mount the
systems and observe the technical information in the main
catalog.
Intended use of the mounting kit for the systems also
requires that
W
you comply with these instructions,
W
you comply with all accompanying documents,
W
you comply with national accident prevention
regulations at the site,
W
you assemble and operate the systems only in
industrial areas,
W
only trained and qualified personnel mount the DIN rail.
SIGNAL WORD
CAUTION
Adhere to the following instructions
O Before working on the system, switch off the pressure
and voltage.
O Make sure that the tie rods have been completely
screwed into the EP end plate before mounting the
valve block.
O Check that the DIN rail is positioned correctly.
3

Delivery contents

(Order number: 1827010709)
1
See :
W
Screws DIN ISO EN 4762:
– 2x hexagon socket screws M6x65 (B)
– 1x hexagon socket screw M6x8 (C)
W
1x washer
W
2x clamps (A)
4

Assembly and disassembly

Danger due to sudden pressure release and applied
voltage
System components under pressure or voltage during
assembly present a danger of injury.
O Make sure that the system component to be
installed is not under pressure or voltage before
beginning assembly.
O Assembly work may only be carried out by trained
professionals.
O Pay particular attention to the valid and relevant
local safety regulations.
Danger of personal injury due to uncontrolled
movements!
The system can come loose from the DIN rail through
vibration, shock or oscillating loads. The loose parts can
lead to injury and damage to equipment.
O Make sure that the DIN rail is not subject to vibration,
shock or oscillating loads.
Follow the steps below to ensure safe assembly and
disassembly.
CAUTION
CAUTION
3