Maintenance - Ayce 1328 Gebrauchsanweisung

j. On/off switch (Fig.10)
3. Operation for working
NOTE: The tool is equipped with an anti-vibration back handle for additional comfort,
easy control and to reduce user fatigue.
a. Using the router
1. Make sure that the material to be cut is securely clamped and provides
sufficient stability to support the router while it is operating.
2. To control the router, keep both hands on the grips.
3. Rotate the router counter-clockwise when cutting outside edges. Rotate it
clockwise when cutting inside edges.
4. Always hold the router from the front, ensuring that the chip shield is between
yourself and the bit.
5. After setting the cutting depth as described, position the router so that the
bit is directly above the point you plan to cut. With the router running, lower
the unit smoothly into the work-piece. (DO NOT FORCE THE ROUTER DOWN.)
When the tool reaches its pre-set depth, tighten the plunge release lever.
Once you have finished routing, loosen the plunge release lever and allow the
spring to lift the router directly out of the work-piece.
NOTE: Always feed the work-piece to the router against the direction of the bit's
rotation.
b. Direction of feed
The feed motion of the router must always be carried out against the rotation direction
of the router bit (up-grinding). When milling in the direction with the rotation of the
router bit (down-cutting), the router can break loose, eliminating control by the user.
180619_ayce_1328_IM
The tool is equipped with a lock-off
button to avoid unintentional starting.
! Before plugging the tool
into the power point
always check that the
trigger switch and
WARNING
lock-off button work
properly.
To switch on, depress the lock-off
button and squeeze the trigger switch.
To switch off, release the trigger
switch.

MAINTENANCE

CAUTION!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
94 95 | GB
GB
180619_ayce_1328_IM