Operation - Gastro M C-800 Installationsanleitung

Your icemaker has adjusted from factory to function after installation, without any
other need of technician. The settings are default settings for the majority of users.
However here and after described the adjustments can be done from you in order
the icemaker to perform upon your needs.
The icemaker comes with a panel that performs most of the adjustments. You can
increase or decrease the size of ice. Same you can act if the ambient working
temperature of the icemaker is up to 25Celsius.
Your icemaker been adjusted from the factory to function after installation, without
any other need of technician. However, here you will find how to adjust your
icemaker. Please note the adjustments are so easy to be done without the need of
technical knowledge
Pull up the front cover of device and the adjustment switches will appear.
Do not fluctuate marginal the adjustments; on left end position the icemaker stops to
function. On right end position the icemaker will make a big
thing happened you must stop the icemaker and wait till the ice melts. Or you can
make the ice melt quicker by boiling water and pour it on top of icemaker, after you
take off first the top cover. So please make adjustments gradually per working cycle,
till you will be satisfied with the size of ice.
Turn the middle screw-type switch clock-wise in order the icemaker to fully the ice
bin storage. Same turn anti-clockwise in order the icemaker to fill the ice bin less.
The orange switch is the timer and ONLY authorized personnel should adjust this
switch.

OPERATION:

.
Find the screw type with the numbers around it.
This switch enables the fluctuation of the size ice size.
With a screwdriver turn the switch right for increasing
volume in each ice piece. Alternatively, turn it left to
decrease volume in each ice piece. Minimum weight
10grams and max 32grams.
16
mass of ice. If such