Summary; Installation Manual; Unpacking; Scope Of Delivery - FLORABEST FLH 2500 A1 Originalbetriebsanleitung

Summary

A
1 Wheels
2 Collector box
3 Safety switch
4 Shredder unit
5 Mains cable with strain relief
6 Transport handle
7 Reset switch
8 Funnel feeder
9 Operating mode selection switch
10 Pusher
11 Adjustor screw
12 Chassis
13 Supports

Installation manual

Unpacking

1. Remove the shredder from the
packaging.
B
2. Pull the collector box (2) out of
the chassis (12) and take out the
shredder unit and accessories.
3. Check the scope of delivery:

Scope of delivery

• Operation and Safety Notes
• Shredder unit
• Chassis
• Collector box
• Two running wheels and two adjust-
able feet with assembly material
• Spanner
• Allen key
• Pusher

Assembling the shredder

C
Assemble the two running
1
wheels (1). Clip in the wheel
covers into the running wheels.
Screw on the two adjustable feet
2
(13) to the chassis (12).
Fix the cutting attachment (4)
3
onto the chassis (12) with the
four screws enclosed.
4. To insert the collector box
( 2), the safety switch(see
A
picture
D
i.e. in the "OFF" position. Push
the collector box (
chassis (
switch (
wheels (
( 2) can be pushed in only in
A
one direction.
5. Lock the collector box (
pushing the safety switch (Fig
) to the ON position.
D

Operation

Start-up

Before starting the shredder, make sure
that the shredder unit is firmly attached to
the chassis and the collector box and safety
switch are in their proper positions (Fig
The shredder cannot be switched
on before the collector box and
safety switch are in their proper
positions.
Switching the shredder on and
off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.
GB
) must be unlocked,
2) into the
A
11), with the safety
A
3) on the side of the
A
1). The collector box
A
A
MT
2) by
).
D
45