Maintenance; Parts Replacement - Blodgett MT1820 serie Handbuch

CLEANING
NOTE: DO NOT spray the oven with a water jet.
Daily
1. Remove and clean the crumb pans.
2. Clean the conveyor belt with a brush.
Every 3 months
1. Clean the axial fan guards.
Every 6 months
1. Remove the conveyor.
2. Clean the inside of the oven.
Every 12 months
A factory authorized service person should:
1. Clean the control panel, oven cavity and fans.
2. Check the main electrical connections.
3. Check the drive motor.

Maintenance

Cleaning and Parts Replacement

PARTS REPLACEMENT

Electrical Components
1. Turn off the main electrical connection.
2. Remove the control box cover.
3. Replace the defective components.
To replace the temperature sensors, remove
the back panel and insulation. The sensors
are located on the top of the blower outlet
duct.
4. Replace the control box cover and/or insula-
tion and back panel
5. Turn on the main electrical connection.
Cooling Fans/Blowers
1. Turn off main electrical connection.
2. Remove the oven back panel. Remove insula-
tion if necessary.
3. Disconnect and replace the defective fans.
4. Reinstall the insulation and oven back panel.
5. Turn on the main electrical connection.
Operating Panel Components
1. Turn off main electrical connection.
2. Remove the screws located on the bottom of
the oven holding the control. Slide the operat-
ing panel out.
3. Replace the defective component.
4. Reinstall the operating panel.
5. Turn on the main electrical connection.
9