Ryobi RHT25X60RO Bedienungsanleitung Seite 21

WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
■ You may make adjustments and repairs described in
this manual. For other repairs, contact the authorised
service centre.
■ Consequences of improper
include excess carbon deposits resulting in loss of
performance and discharge of black lubricant residue
dripping from the silencer.
■ After each use, clean the body and handles of the
product with a soft, dry cloth.
■ After each use, clean the debris from the blades
with a stiff brush, and then carefully apply a rust
preventative lubricant before refitting the blade
protector. The manufacturer recommends you to
use a rust preventative and lubricant spray to apply
an even distribution and reduce the risk of personal
injury from contact with the blades. For information
about suitable spray product, check with your local
authorised service centre.
■ You may wish to lubricate the blades lightly before use
if necessary using the above method.
■ Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
REPLACING THE BLADES
■ Periodically inspect the blades for damage and wear.
If any blades are damaged, they should be properly
repaired or replaced by an authorised service centre.
LUBRICATING THE BLADE
See fi gure 5.
■ For easier operation and longer blade life, lubricate the
hedge trimmer blade before and after each use.
■ Stop the engine and disconnect the spark plug wire.
Lay the hedge trimmer on a flat surface. Apply light
weight product lubricant along the edge of the top
blade.
■ If you will be using the hedge trimmer for an extended
period, it is advisable to lubricate the blade during use.
NOTE: Do not lubricate while the hedge trimmer is
running.
English (Original instructions)
CLEARING A BLOCKAGE
■ Stop the engine and wait for all moving parts to stop.
■ Disconnect the spark plug wire.
■ The blades are sharp. Wear heavy-duty gloves when
■ Carefully clear away the blockage or debris from
CLEANING THE HEDGE TRIMMER
■ Clean the blades using a stiff brush.
■ Slide the scabbard over the blade.
maintenance may
■ Clean dirt and debris from the body of the hedge
CLEANING THE AIR FILTER
See fi gure 6.
■ Stop the engine and disconnect the spark plug wire.
■ For proper performance and long life, keep the air filter
■ Loosen and remove the air box knob.
■ Remove the air box cover from the engine.
■ Remove the air filter.
■ Clean the foam filter. If damaged, replace immediately.
■ Reinstall the foam filter.
■ Reinstall the air filter.
■ Replace the air box cover.
FUEL CAP
■ The fuel cap contains a non-serviceable filter and
■ Replace fuel cap with an identical replacement from
A leaking fuel cap is a fi re hazard and must be replaced
immediately. Failure to do so could result in a fi re that
could cause serious personal injury.
19
working near the blades.
around the blades or other moving parts.
trimmer, using a brush or damp cloth.
NOTE: Do not use any strong detergents on the
plastic housing or the handle. They can be damaged
by certain aromatic lubricants such as pine and lemon,
and by solvents such as kerosene.
clean.
a check valve. A clogged fuel filter will cause poor
engine performance. If performance improves when
the fuel cap is loosened, check the valve. The valve
may be faulty or filter may be clogged.
an authorised service centre if required.
WARNING