Adler europe AD 7915 Bedienungsanweisung Seite 4

20. Do not move the device when the inner tank is filled with water.
21. Do not place any objects on the device.
22. The device can be used only with properly working ventilation.
DEVICE DESCRIPTION (Fig. A).
1. Air outlet opening
4. Carrying handle (on both sides)
7. Water tank
10. Mesh filer's frame
USING THE DEVICE
A noticeable reduction in the temperature of the outlet air occurs after putting into the water tank plastic containers attached to the
product previously frozen in the freezer. It is recommended to fill the tank with cold tap water.
1. Place the unit on a dry, flat surface and connect to the power supply.
2. Pull out the water tank (7) from the back of the machine and pour in the water (Fig. B). Be careful not to exceed the maximum level.
3. Turn on the device using the "ON/OFF " button on the control panel (Fig. C).
4. The SPEED button on the control panel allows you to change the speed of the blower unit. The following speeds can be selected:
HIGH (fast), MIDDLE (medium) and LOW (slow).
5. COOL button lowers the temperature of the air by running the water pump. Additionally, a set of two boxes is attached. Boxes are
filled in special gel that is able to frozen and un frozen and no need to open them.
To use them, put them on 24 hours inside the freezer. Then put one or both of ice boxes into water tank (7). To blow the cool air, the
device must be filled with water. When the device is operating, periodically check the water level to see whether to add water.
6. Pressing the SWING button starts the oscillation of vertical slats that provide even distribution of cold air stream in range 120°.
Horizontal slats do not move automatically, so if necessary, manually adjust them to point up or down.
7. The TIMER button allows for programming the amount of time during which the device will operate before turning itself off
automatically (if the TIMER function is not used, the device will work until it is manually turned off). Time range 1 – 12 hours.
8. The MODE button allows for changing the fan mode. In addition to the normal mode, you can select "NATURE" and "SLEEP." The
NATURE mode mimics the natural wind action by repeating the fan speed sequence: middle speed (12 seconds) -> low speed (6
second) -> high speed (3 seconds) -> middle speed (6 second) -> low speed (6 second). The „SLEEP" mode operated in repeating
the fan speed sequence: middle speed (6 seconds) -> low speed (3 seconds).
9. The button on remote control (9) is same as the control panel (8). Don't put the stuff in the front of the remote control receivers.
CLEANING AND MAINTENANCE
1. Clean with soft, dry cloth. Do not use chemical solvents because they can cause permanent damage or deformation of the device.
2. If the device is not used for three or more months, take the batteries out of the remote control.
3. After long time operation, the mesh filter (5) and mesh filer's frame (10) will be clogged with the dust, which will greatly affect the
machine's performance of cooling. If long time no changing water, there may be mold and mildew. We suggest to clean the mesh
filter (5) and mesh filer's frame (10) once every two weeks. The clean procedure is as below:
a) Unplug the device, remove the screw of the back housing and then take the frame and filter out.
b) Wash the filter in a mild detergent and warm water solution, then rinse in clean water.
c) Wash the mesh filer with flowing clean water. Use a soft brush for cleaning.
4. Drain the water before storage by removing the drain plug at the bottom of the water tank. Then dry the device, mesh filter, mesh
filter's frame and housing to aviod the moisture damage.
TECHNICAL DATA:
Power source:220-240 V ~50 Hz
Power: 65 W Power Max: 350 W
Tank capacity:7 liters Water Consumption: 0,5 – 0,6 liter / hour
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
LESEN SIE AUFMERKSAM WICHTIGE ANWEISUNGEN BEZÜGLICH DER SICHERHEIT
DER BENUTZUNG BEWAHREN SIE DIESE FÜR DIE ZUKUNFT AUF
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1. Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen
Hinweise beachten. Der Produzent trägt keine Verantwortung für Schäden, die aufgrund
2. Water level indicator
5. Mesh filter
8. LED Touch control panel
ALLGEMEINE SICHERHEITSVORSCHRIFTEN
Device is made in class I of insulation and has to be connected
only to power outlet with ground circuit.
Device is compliant with EU directives:
Low voltage directive (LVD)
Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
DEUTSCH
4
3. Wheels
6. 2 plastic boxes with gel to frozen
9. Remote Control