(A) Zone Registration Using The Wired Remote Controller (Rbc-Amt31E) - Toshiba TCB-CC163TLE Installations-Handbuch

(a) Zone registration using the wired remote controller (RBC-
AMT31E)
(Determination of central address)
● This method is not supported by the RAV models. For RAV models,
initiate the zone registration described in (a).
● In this case, after confirming which indoor unit is connected to the
remote controller and that the air conditioner in the OFF state, you
set the central control addresses one at a time.
● If the system has no remote controller, connect a remote controller
to the system temporarily. Then follow this procedure.
NOTE
The indoor unit address must already have been set before performing
zone registration. If necessary, refer to the Installation Manual supplied
with the outdoor unit.
(1) Press the and
controller for more than 4 seconds.
(2) Do not press
(3) Once in this mode, the UNIT No., CODE No., No. of SET DATA and
indications will flash on the display as shown Fig. 9.
NOTE
In case of group control "ALL" instead of "UNIT No." will flash on the
display. Select the main indoor unit address by pressing the
button once.
(4) Set CODE No. to 03 using the
NOTE
The CODE No. 03 must be selected to perform zone registration using
the remote controller.
(5) Set the Central control address which you want to assign to the
indoor unit address using the
according to the zone registration table.
(6) Press the button. The CODE No. and Central control address
changes from flashing to ON state. If you make mistake, then press
the button and reset the central control address.
(7) Press the button to finish zone registration.
16
buttons at the same time of the remote
button.
and
and
( ) buttons.
( ) buttons
For example, in this case
Indoor unit address:1-8
Central control address :
Fig. 9
17 (ZONE 2, GROUP 1)
Fig. 10
OI-744-16EG