Athena JumpStarter Bedienungsanleitung Seite 7

H. WARNING:
1. If not used the device needs to be recharged at least every 6 months or after every use.
2. JumpStarter should never be completely discharged for more than 20 days. Beyond this
term, the device may partially or totally lose its functionality.
3. Read the instruction manual carefully before using this product.
4.The JumpStarter device has been designed and tested only and exclusively for starting 12V
up to 2000cc vehicles (not suitable for Diesel vehicles). Using this device to start other vehicles
may be dangerous and is forbidden with means of transport such as aircraft, ships and so on.
5. The outlet port which the jump cables have to be connected to the JumpStarter is marked with
a rubber cap with an open hood car. Please, connect only the clamps included in the package
to this port. Use of ports or devices other than the harnesses included in the JumpStarter
package can damage – partially or totally - both JumpStarter and what is connected to it.
6. Exercise caution in using the device.
7. DO NOT use the product if the cable clip or the cable itself are damaged.
8. DO NOT use as a substitute for the vehicle's battery.
9. DO NOT use as a battery charger.
10. DO NOT leave the device connected to the battery of the vehicle after this has been
successfully started. Remove the product from the vehicle battery within 30 seconds from
starting, to avoid any damage.
11. Only use the starter cable supplied with the device.
12. Ensure that the blue plug of the starter cable is properly connected to your JumpStarter's
socket to prevent the cable from melting.
13. Check that all battery connections are CLEAN before starting the vehicle using your
JumpStarter. Ensure the battery clips are properly connected. If the vehicle battery
terminals are dirty or corroded, the unit's power supply may be lessened.
14. DO NOT connect two clips together.
7
EN