Athena JumpStarter Bedienungsanleitung Seite 3

B. USER GUIDE:
Charge indicator
Press the button to check the JumpStarter's charge level:
Indicator
Storage level
The led lights will come on one after the other during charging. The number of leds lit up
shows JumpStarter's charge level (see table above). All the leds will go out when charging is
completed or interrupted.
How to recharge JumpStarter:
1. Connect the USB charger cable to a charger (not included) or USB port.
2. Connect the micro USB to the device's 5V2A input port
How to start petrol vehicles (12V) using JumpStarter :
1. Completely insert the blue plug in the JumpStarter and ensure the charge indicator is off.
2. Connect the red clip to the battery's positive (+) terminal and the black clip to its negative (-) terminal.
It is recommended not to invert the two clamps for any reason.
No light 1 Led
0% 25%
3
2 Led 3 Led 4 Led
50% 75% 100%
EN