Velleman CAMCOLMS2 Bedienungsanleitung Seite 10

CAMCOLMS2
Click the calibration icon and move the cursor to the picture.
Click the start and end points across a known value. Enter the exact measurement values in the dialogue
window.
The software will automatically calibrate the magnification rate. Click OK; the adjusted magnification rate
will show in the upper right corner.
Click on the angle line icon to measure the values again. The microscope is calibrated if these last values
correspond (or differ slightly) to the values entered before.
V. 01 – 20/09/2016 10 ©Velleman nv