HQ Power VDPL1503MHW12 Bedienungsanleitung Seite 6

• A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR
plug with a 120Ω resistor between pins 2 and 3, which is then plugged into the XLR output
socket [5] of the last device in the chain.
c) general
• Have a qualified electrician carry out the electrical connection.
• Connect the device to the mains with the power plug. All fixtures must be powered directly off
a grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the
rheostat or dimmer channel is used solely for 0% to 100% switch.
• The installation has to be approved by an expert before the device is taken into service.
d) Replacing the fuse [8]
• Only replace the fuse by a fuse of the same type and rating.
• Before replacing the fuse, unplug mains lead.
• Unscrew the fuse holder on the rear panel of the base with an appropriate screwdriver.
• Remove the old fuse and install the new fuse in the fuse holder.
• Replace the fuse holder in the housing and tighten it.
6. Operation
Refer to the illustrations on page 2 of this manual.
Control Panel Navigation
• Access the control panel functions using the four panel buttons [11] located directly underneath
the display [10]. From left to right:
button
<MENU> used to access the menu or to return to a previous menu option
<UP> scrolls through the menu options in ascending order
<DOWN> scrolls through the menu options in descending order
<ENTER> used to select and store the current menu or option within the menu
• The control panel display shows the menu items you select from the menu map. When a menu
function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
• Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press
<ENTER> to access the menu function currently displayed or to enable a menu option. To return
to the previous option or menu without changing the value, press the <MENU> button.
Main menu functions
menu
DMX-mode
stand alone
mode
(auto run)
Master/slave
mode
Submenu Functions
submenu
pan
tilt
display
direction
15/11/2011
VDPL1503MHW12
display
Set DMX starting address between 1 and 512.
sound activation mode
slow mode
fast mode
standby mode
mode 1
mode 2
mode 3
mode 4
display
pan clockwise
pan inverse
tilt clockwise
tilt inverse
normal display
180° rotated display
function
function / description
function / description
6 ©Velleman nv