Inhaltsverzeichnis
Werbung
GBR
OPERATION INSTRUCTION
Make sure that water tank is empty before starting to use. Pour out water after the end of working with steam cleaner. There never should be
water in tank when appliance is not in use to avoid calcification.
Plug the power cord of device into the power socket and push power ON/OFF button on rear panel of unit. Wait until green LED-indicator is
ON. Green LED-light means appliance is ready to work.
Note - pressure in the water tank is 4 bar!
Fix attachment which you need in advance. Please follow our recommendations in use of attachments.
Don't start to work with appliance until you see steam without water from the steam outlet. For the first use some water can be released with
steam. This is normal for about couple of minutes after the very first start. If you face the same problem in further use; please contact
authorized service center.
Push the steam release button on handle while cleaning. You may also adjust steam amount with appropriate regulator. Keep a check on the
LED-indicator. While LED is green; steam cleaner is in working status; if LED is red; it means the water tank is empty and needs to be refilled
for further operation. Turn OFF power and cool the appliance before starting to pour water in tank. There is a kid lock button (point 4 in chapter
―STEAM GUN PARTS‖) on the handle. Please use that lock to avoid unsafe way of use the appliance.
ATTENTION: Be careful while refilling hot water tank. Always wait until it is completely cooled and water tank doesn't contain hot water
inside to avoid burns of skin. Always turn OFF the power and cool device before water refill.
Always make sure that steam is totally released from steam cleaner before storage.
Never open up the steam valve before device is cooled and steam released! Pour water only in cooled tank!
Open up the water tank turning steam valve clockwise. Please use
measuring cup to fill the tank. Please remember that water tank
capacity is 1,5l. Never pour any liquids but water to fill the tank.
Always close the steam valve before turning steam cleaner ON and
starting operation.
ATTENTION: Make sure that there is at least 0, 5 – 1, 2l of water
in tank before starting to work with device.
11
MT-1172
Werbung
Inhaltsverzeichnis
