Description Of The Appliance; Identification Data; Preliminary Phases For Use; How To Make Coffee - Ariete Caffe Novecento 1387A Bedienungsanleitung

DESCRIPTION OF THE APPLIANCE

A - On/off button
B - Control lever
C - Boiler temperature thermometer (°C and °F)
D - On indicator lamp
E - Boiler temperature control lamp
F - Steam function indicator lamp
G - Machine body
H - Water/steam dispensing lever
I - Water tank
J - Maxi Cappuccino attachment and wand for
water and steam supply

Identification data

The following machine identification data are shown on the plate found underneath the machine's standing
base:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.

PRELIMINARY PHASES FOR USE

Starting the appliance
Check that the voltage of the domestic network is the same as that indicated on the technical information plate
of the appliance. Place the appliance on a flat surface.
Wash the tank the first time it is used and fill it with cool tap water up to the level marked "MAX", then be careful
to put it back into its seat securely (Fig. 3) following the relevant guide on the bottom of its housing (Fig. 4).
Make sure that the control lever (B) is in the vertical standby position (Fig. 5). Insert the plug into the socket,
which must be earthed.
If water drips out of the pipe inside the tank, this does not mean the machine is faulty but it is a sign
that the priming valve is working normally.
Starting the first time
After having filled the tank up to the "MAX" level with cool tap water, start the machine by pressing the button
(A). The indicator light (D) will switch on indicating that the machine is on. Make at least one cup of water come
out of the hydraulic circuit of the boiler by pulling the control lever (B) forward and down, Fig. 8, until you see
water come out of the filter holder coupling seat (Fig. 9). Put the lever back in the vertical standby position.
The indicator light (E) will switch on to indicate that the boiler has reached the right temperature to brew coffee.
The machine is ready to make coffee.
Warning!
Remove at least one cup of water from the boiler hydraulic circuit whenever the appliance is turned on
the first time or after it has not been used for a period of time, by pulling the water/steam dispensing
lever (H) forward after placing a container under the Maxi Cappuccino device wand (J) Fig. 10. Push
the dispensing lever back to stop water dispensing.
You will notice that the indicator lamp (E) will turn off, indicating that the boiler has reached the right tempera-
ture for preparing the beverage.

HOW TO MAKE COFFEE

Put the Thermocream® Disc (Q), the perforated silicone disk (P) and the Thermocream® Filter (O) into the
16
L - Power cord
M - Cup-resting grill
N - Drip tray
O - Thermocream® Filter
P - Perforated silicone disc
Q - Thermocream® Disc
R - Filter holder
S - Spout for one cup
T - Spout for two cups
U - Coffee measure
V - Coffee presser