Transportation, Storage And Disposal - Husqvarna K 7000 Bedienungsanweisung

4. Remove the belt from the pulley.
Note: The cutting head can be removed from the
product.
Transportation and storage
• Secure the product during transportation to prevent
damage and accidents.
• Remove the cutting blade before transportation or
storage of the product.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the cutting blades in dry, frost free conditions.
• Examine all new and used blades for transport and
storage damage before assembly.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
24

Transportation, storage and disposal

5. Loosen the 2 screws that hold the belt guard.
6. Remove the rear belt guard.
7. Replace the drive belt.
8. Assemble in opposite sequence. To install the
cutting blade, refer to
page 14 .
To install the cutting blade on
1448 - 003 - 13.02.2020