Husqvarna K 7000 Bedienungsanweisung Seite 13

CAUTION: Do not use diamond blades with
positive rake angles.
CAUTION: Do not use diamond blades with
greater gap between segments than max 10
mm (A).
A
CAUTION: Do not use diamond blades with
greater blade thickness than recommended
maximum, refer to
blade dimensions on page 26 .
CAUTION: Some cutting situations and worn
blades may cause increased wear on the
side of the segments. Replace the blade
before it is worn out.
Toothed blades
WARNING: Never use toothed blades such
as wood cutting blades, circular toothed
blades, carbide tipped blades, etc. The risk
of kickback is significantly increased and tips
can be torn off and thrown at high speed.
Carelessness can result in serious personal
injury or even death.
WARNING: Government regulation requires
a different type of guarding for carbide
tipped blades not available on power cutters
– a 360 degree guard. Power Cutters (this
saw) use diamond blades and have a
different guarding system which does not
1448 - 003 - 13.02.2020
Recommended cutting
provide protection against the dangers
presented by wood cutting blades.
Use of this power cutter with a carbide tipped blade is a
violation of work safety regulations.
Due to the hazardous nature and exigent circumstances
involved with fire fighting and rescue operations
conducted by the various highly trained public safety
forces, safety professionals (fire departments),
Husqvarna is aware that they may use this power cutter
with carbide tipped blades in certain emergency
situations due to the ability of carbide tipped blades to
cut many different types of obstructions and materials in
combination without having to take time to switch blades
or machines. When using this power cutter be aware at
all times that carbide tipped blades are more kickback
prone than diamond blades if not used properly. Carbide
tipped blades can also throw pieces of material away
from the blade.
For these reasons, a power cutter equipped with a
carbide tipped blade should never be used except by
highly trained public safety professionals who are aware
of the risks associated with its use and then only in
those exigent circumstances when other tools are
deemed inefficient and ineffective for fire or rescue
operations. A power cutter equipped with a carbide
tipped blade should never be used to cut wood in non-
rescue operations.
To examine the spindle shaft and the
flange washers
CAUTION: Use only Husqvarna flange
washers with a minimum diameter of 105
mm/4.1 in.
WARNING: Do not use defective, worn or
dirty flange washers. Use only flange
washers of the same dimension. Incorrect
flange washers can cause the cutting blade
to become damaged or come loose.
Examine the spindle shaft and the flange washers when
you replace the cutting blade.
13