Maintenance Schedule; Maintenance - Husqvarna K 7000 Bedienungsanweisung

Indication
All the status indica-
tion lamps flash.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional

Maintenance schedule

Maintenance

Clean the external parts of the product.
Do a general inspection.
Make sure that the power trigger and the power trigger lockout
operate correctly from a safety point of view.*
Do a check of the cutting blade. Look for cracks and make
sure that the cutting blade is not unusually worn. Replace if it is
necessary.**
Do a check of the drive wheel.
Do a check of the drive belt.
Do a check of the water system.
Do a check of the vibration damping system.*
Do a check of the blade guard.
Safety devices on the product on page 9 .
* Refer to
To install the cutting blade on page 14 .
** Refer to
22
Cause
The product is too hot.
The power is decreased.
The system is in automatic shutdown.
Maintenance
Step
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
Increase the water flow or airflow
to decrease the temperature.
Put the power pack in a location
with lower temperature.
Replace the air filter.
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Weekly or each
Daily
X
X
X
X
X
X
Monthly
40 h
X
X
X
1448 - 003 - 13.02.2020