Preparations; Viewing Direction; Location; Installation - Fujitsu MYRICA serie Betriebsanleitung

Preparations

Preparations

Viewing direction

D Despite the large viewing angle the LCD/plasma TV
offers the best performance with a directly vertical view-
ing direction. Align the LCD/plasma TV with the most
frequently used viewing direction.

Location

D Light reflection
Avoid locating the unit opposite windows or other light
sources.
D Access to the mains input
The mains input and mains switch should be easily
accessible at all times.
D Air supply
To ensure sufficient ventilation, the supply air and
exhaust air openings of the LCD/plasma TV must be
kept absolutely free.
If installed in an alcove, keep the minimum distances
large enough to allow sufficient ventilation of the LCD/
plasma TV.
LCD TV: A = 5 cm; B = 10 cm
Plasma TV: A = 10 cm; B = 20 cm
Ensure the following minimum spacings for wall moun-
ting:
LCD TV: A = 10 cm; B = 20 cm
Plasma TV: A =20 cm; B = 30 cm.
8
Downloaded From TV-Manual.com Manuals
D Ambient temperature
For safe and reliable operation the ambient temperature
must be between 5 °C and 35 °C.

Installation

D Two persons are required to remove the LCD/plasma TV
from its packing. Never lift the LCD/plasma TV alone.
An attempt to lift the LCD/plasma TV alone will put your
health at risk.
D Place the LCD/plasma TV on a stable and horizontal
base. The subsurface must be firm and capable of bear-
ing a static load.
D Before installation make sure that the LCD/plasma TV is
switched off and that the mains cable and signal cable
are unplugged.

Wall mounting

D The plasma TV must be mounted on vertical walls only.
D Before mounting the set, check whether the loadbearing
capacity of the wall is suitable for 3-times the weight of
the LCD/plasma TV (for the weight see page 31 "Techni-
cal specifications"). If in doubt, seek the advice of a
qualified installer.
D Before installation make sure that the LCD/plasma TV is
switched off and that the mains cable and signal cable
are unplugged.
D Two people are required for the mounting work.
D Turn the LCD/plasma TV so that the front side (screen)
is pointing downwards and place it carefully on a com-
pletely flat and firm surface.
D Loosen the 6 screws (M4x10) in the table feet and
remove them.
Fastening screws in the table feet
ENGLISH