Network Configuration; Default Network Properties; Network Configuration With Sympholight - OSRAM e:cue SYMPL input Node Installationsanleitung

Network configuration

5 Network configuration
The configuration of the e:cue SYMPL input Node is done via e:cue
SYMPHOLIGHT. See the SYMPHOLIGHT System Manual for details on
configuration, available at www.ecue.com.
The network properties of the SYMPL input Node are preconfigured. The
successful installation of the power supply is required for changing the
network configuration. You can either adjust the network settings with
SYMPHOLIGHT or using the web interface of the SYMPL input Node.
5.1

Default network properties

The SYMPL input Node has as factory setting the default IP address
192.168.123.1.
DHCP is enabled by default.
To change the network configuration use either SYMPHOLIGHT or the web
interface of the SYMPL input Node:
5.2

Network configuration with SYMPHOLIGHT

1. Open the context menu of the SYMPL input Node in the Setup tab
of SYMPHOLIGHT by a right-click on the device.
2. Select "Configure Network":
16