Electrolux UK 120510 RE Gebrauchsanweisungen Seite 52

2. Two cabinet securing brackets (D) are supplied
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
Left hand
bracket
2
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
+
-
-
+
max. 890 mm
3
3. Push the appliance into place. The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw in
the front kick plate to the left or right.
52
Right hand
bracket
4. The joint cover (B) is to be assembled after having
installed the appliance in the recess.
5
5. Screw appliance into place and retain the cabinet
with screws
the worktop or adjacent woodwork as necessary.
1
4
(I) through the securing brackets into
I