Philips sbc ru 120 Bedienungsanleitung Seite 4

XP SBC RU 120
Instructions for use
A
Carefully read the complete procedure before starting!
You do not know the brand of your equipment/
you can not find the right code in the code list »
auto search:
1
2
3
– Each time the green LED flashes, another code is sent.
If you accidentally press the power key again, after the
equipment switched off, you miss the correct code!
If you accidentally skipped the code follow the next
procedure starting at step 4. If you did not skip the code go
to step 7.
4
5
PROG
-
6
7
– The green LED flashes twice.
C
Switch equipment on manually. Press a few keys to check correct
response. If response is not correct, repeat procedure beginning
at step 1.
N
- The search time averages about 90 seconds.
(Maximum search time is 5 minutes).
- If the LED blinks twice, after you pressed the power key (step 3),
this means you have tried all codes. If non of the codes worked,
try the Autosearch procedure again, starting at step 1.
4
16-06-2000 10:29
D V I C E
Be sure your device is switched on.
Press and hold keys mute and power simultaneously -for
about three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
Press the power key repeatedly until the equipment
switches off. Make sure that you keep the remote control
pointed at your equipment.
When the right code is found, the equipment switches off.
Switch the equipment manually back on.
Press 'PROG–' (down only!) a couple of times.
Press the power key repeatedly until the equipment
switches off.
Press the mute key to lock the correct code in the SBC
RU120's memory.
H E C K
O T E
Pagina 4