Herunterladen Inhalt Inhalt Diese Seite drucken

Mode Re-Assignment; Troubleshooting - One for All URC-6230 Bedienungsanleitung

Universal fernbedienung
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 7
It is possible to change the mode of any device key. This is useful if you want to set up two of
the same devices on the ZAPPER. The code can be set up using "Direct code set up" (page. 4) or
"Search Method" (page. 5). To change a device key, see the example below.
Example: to program a second television on the SAT key.
1
Open the flap to enable access to the MAGIC key.
2
Press and hold the MAGIC key until the LED blinks twice (The LED underneath the
POWER key will blink once then twice).
3
Press and release OK (mute) then DOWN then RIGHT. The LED underneath the POWER
key will blink twice.
4
Press TV.
5
Press SAT. The LED underneath the POWER key will blink twice. The SAT key has now
become a second TV key and can be used to program a second Television.
Problem:
Your brand is not listed in
the ZAPPER code section?
The ZAPPER does not operate your
device?
The ZAPPER is not performing
commands properly?
You cannot reach channel 10
and above on your TV.
The ZAPPER does not respond after
pressing a key?
LED does not blink when you press a
key?
In the UK
E-mail : ofahelp@uebv.com (*)
Fax
: +31 53 432 9816
Tel.
: 0901-5510010 (£ 0,50 per minute)
In Australia
E-mail : ofahelp@uebv.com (*)
Fax
: 03 9672 2479
Tel.
: 1 300 888 298
In New Zealand
E-mail : ofahelp@uebv.com (*)
Fax
: (06) 878 2760
Tel.
: 0508 ONE 4 ALL (663 4 255)
Slovakia
E-mail : ofa@dsi.sk
Fax
: +421 55 611 8111
Tel.
: +421 55 611 8131
Web.
: www.dsi.sk
(*)
Just send a blank message, you'll get auto-reply.
6

Mode re-assignment

Troubleshooting

Solution:
Try the search method.
A) Try all the codes listed for your brand.
B) Try the search method.
You may be using the wrong code. Try Direct Set-Up
again trying each code listed under your brand or
start the search method over again to locate the
proper code.
If your original remote did not have CHANNEL +/-
keys, the ZAPPER may not operate this function.
Make sure you are using new batteries and are
aiming the ZAPPER at your device.
Replace batteries with 2 new "AAAA" alkaline
batteries.
Customer Service
In Ireland
E-mail : ofahelp@uebv.com (*)
Fax
: +31 53 432 9816
Tel.
: 016015986
In South Africa
E-mail : support@oneforall.co.za
Fax
: 011 298 2302
Tel.
: 0860 100551
Tel.
: 011 4173000
Ukraine
E-mail : alexx@ckc.com.ua
Fax
: +38 044 4890187
Tel.
: +38 044 4890188
Web.
: www.oneforall.com.ua
Croatia
E-mail : lucija@tehnocentar.hr
Fax
: +385 1 48 16 807
Fax
: +385 1 48 16 806
Web.
: www.tehnocentar.hr
WWW.ONEFORALL.COM

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Urc-6231

Inhaltsverzeichnis