Bahco BCL33AP1 Betriebsanleitung Seite 7

5. SPECIFIC SAFETY RULES AND/OR SYMBOLS
Recycle
....................
Class II Tool
....................
Do not incinerate and put the battery
on fire
..................
Do not wet
....................
a.c. Alternating Current
.................
Watts
W
.......................
Hz Hertz
....................
kg Kilograms
....................
kg-cm Kilograms - Centimeter
......
6. FEATURE
2
7. OPERATING INSTRUCTIONS
Removing or Installing Battery Pack
Charging the Battery Pack
3
4
1. Always switch off the machine before insertion or removal of the
battery pack.
2. To remove the battery pack, push the button on the battery pack
and pull the tool unit from the battery pack in the direction.
3. To insert the battery pack, align the tool unit slides with the battery
pack sliding groove and push the tool unit into place.
The tool unit can be slide into battery pack in two directions.
4. Do not force the battery pack in sliding it into tool unit. If the battery
pack does not slide in easily, it is not being inserted correctly.
1. Connect the plug to the charger before charging.
2. Plug the fast charger into the power source.
3. Slide the battery pack into the charger as the arrow direction shown
on the charger.
4. Push the battery pack into place and make sure the red light on the
charger is "ON". The battery pack is now starting the charging cycle.
5. A fter finish the charging cycle, the light will turn into green. The
battery pack is now ready for use.
• 7
Do not throw in Garbage
....................
Indoor use only
..................
Do not recharge if the battery is broken
or damaged
....................
Risk of electric shock
................
d.c. Direct Current
...............
Volts
V
........................
/min Revolutions or Reciprocations per Minute
............
mm Millimeter
..............
ft-lb Foot-Pound
..............
1
1.
2.
3.
4.
•
Variable Speed Dial
PAD
Main Switch
Side Handle