2 . M O T O R I N S Ta L L A T I O N - Sumitomo IB Series P1 Betriebsanleitung

IB Series P1 Type Operating Manual

1 2 . M o t o r I n s ta l l a t i o n

Follow the process below from (1) through (7) for assembly. (Remove key when assembling shaft
with keyway.)
1. Place reducer on an appropriate worktable with output shaft on the bottom side.
2. Remove fitting of the setting hole of the reducer unit [
3. Match the location by turning by hand to tighten tightening bolt of the coupling into setting
hole of the reducer unit [
4. Insert motor shaft into the center hole of the coupling, press in vertically and fit the pilot part
of the reducer unit and motor.
5. Tighten motor and reducer unit with motor attachment bolt [
6. Tighten coupling tightening bolt through the setting hole of the side of the reducer unit using a
torque wrench bolt as shown in figure below
ening torque.
7. Insert fitting in the setting hole of the joint adaptor.
Fastening bolt
M3
M4
M5
M6
M8
Page 14
in figure below].
. Refer to the table below for necessary tight-
Clamping torque [Nm]
1.67
3.92
7.35
8.83
21.6
Issue: 011/2007
in figure below].
in figure below].
Coupling hole diameter [mm]
ø6–ø8
ø9–ø14
ø16–ø19
ø24–ø28
ø32–ø38
IBP1_ENG_DEU_01_2007_999225