C O N N E C T I O N W I T H O T H E R M A C H I N E S; O P E R A T I O N; D A I L Y I N S P E C T I O N A N D M A I N T E N A N C E - Sumitomo IB Series P1 Betriebsanleitung

IB Series P1 Type Operating Manual

9 . C o n n e c t i o n w i t h o t h e r m a c h i n e s

Confirm the direction of rotation before coupling the unit with the driven machine.
Difference in the direction of rotation may cause injury or damage to the equipment.
Cover the rotating parts; otherwise, injury may result.
When the unit is directly coupled with another machine, check that the direct coupling accuracy
is within the specified limits.
When a belt is used for coupling the unit with another machine, check the belt tension.
Correctly tighten bolts on the pulley and coupling before operation; otherwise, injury may result
because of misalignment.
It is the responsibility of the user to provide guards for all exposed input and output components
such as pulley, couplings, etc.!
9.1 Coupling installation
When installing a coupling, do not impact or apply excessive thrust load to the shaft; otherwise,
the bearing may be damaged or collar may be left.
Thermal shrinking is the recommended installation method.
When gears or sprockets are coupled with the reducer, please use within the range of the allow-
able radial axial load, or shaft and bearing may be damaged.
When Using a Coupling
The accuracy of the dimensions (A, B and X) shown in Fig.1 should be within the tolerance shown
in the table bellow.

1 0 . O p e r a t i o n

Do not approach or touch rotating parts (output shaft, etc.) during operation; otherwise, loose
clothing may be caught in these rotating parts, resulting in serious injury.
Do not put fingers or foreign object into the opening of the reducer; otherwise, injury or damage
to the equipment may result.
The reducer will become very hot during operation. Do not touch or come in contact with the unit;
otherwise, burns may result.
If any anomaly occurs during operation, stop operation immediately; otherwise, injury may result.
Do not operate the unit in excess of the rating; otherwise, injury or damage to the equipment
may result.

11 . D a i l y I n s p e c t i o n a n d M a i n t e n a n c e

Inspection item
Noise
Vibration
Surface temperature
Foundation bolt
Grease leakage
IBP1_ENG_DEU_01_2007_999225
Fig. 1
Details of inspection
Is there abnormal sound?
Is there a sudden change in sound?
Is there abnormally large vibration ?
Does vibration change suddenly?
Is the surface temperature abnormally high?
Does the surface temperature rise suddenly?
Are foundation bolts loose?
Does grease leak from the gear section?
Centering Accuracy of Flexible Couplings
Dimension A Tolerance
Dimension B Tolerance
X dimension
Issue: 01/2007
0.1mm or manufacturer's
specification
0.1mm or manufacturer's
specification
Manufacturer's
specification
page 13