Inhaltsverzeichnis
Werbung
WARNINGS AND USE INSTRUCTIONS
1. System use guidelines
1.1 General description of the system
The system is an electronically-controlled mechanical system for moving cabinet or similar doors on the special sliding
arrangements indicated in the instructions. Each door is equipped with a movement bar, composed of a screw axially connected
to an electric motor, which drives a lead nut attached to the door.
Unless otherwise indicated, the mass limit of each of the doors to be moved is indicated in the technical specifications of the sliding
system with which it is combined.
The system can be activated by a slight push of the door or by the remote control supplied.
1.2 Installation features: program self-learning
The system is able to simultaneously manage up to 4 doors each combined with a movement bar.
The electronic control unit can be combined with movement bars numbered between 1 and 4. In addition to connected doors, the system
also manages various operating modes and programs to match the exact sliding system used.
The system identifies the program to be used based on how the movement bars are connected to the control unit, and each movement
system is supplied with specific instructions for connecting the movement bars.
1.3 Installation features: door track self-learning
The system is equipped with a specific function for setting door track limits. After the system is installed, this function can be activated by
pressing the 'SET/RESET' button on the control unit for 3 seconds. Before activating this function, ensure that the supplied mechanical track
limit stops are positioned according to instructions and that the doors start in the closed position.
This function can be activated at any time and previously memorized track limits will be overwritten.
1.4 Installation features: remote control pairing
This function allows the pairing of the supplied remote control with the desired control unit. The remote control pairing codes are stored in
the receiver.
Multiple control units can be paired and used with a single remote control.
Multiple remote controls can be paired and used with the same control unit.
1.5 Movement control
Following track setting and remote control paring,
the system is operational.
The movement of each door can then be controlled
by a slight push in the opening direction or by using
the remote control.
Manual and remote controls are totally compatible
with each other. The door will move in the desired
direction and then remain stopped until the next
control command.
en
59
Werbung
Inhaltsverzeichnis
