ZAMEL VP-810BHD Handbuch Seite 35

DVR (DIGITAL VIDEO RECORDER)
Start the DVR mode by touching
mode settings.
Automatic DVR operation:
Set DVR to Enable in the System Settings. DVR can record video sequences from each entrance
panel and CCTV camera connected to the video entry phone system.
If motion detection is enabled, the system will automatically record a video sequence up to 7
minutes long in a cycle mode. The cycles of video sequence recording are 1 minute – 1 minute –
1 minutes. If a camera detects movement in its field of view, its video feed will be recorded for 1
minute. Next, the video feed is scanned for motion again. If there is no motion detected, the video
feed recording stops. If there is motion detected, the video feed is recorded for 1 minute again.
Next, the video feed is scanned for motion again. If there is no motion detected, the video feed
recording stops. If there is motion detected, the video feed is recorded for 5 minutes and the
recording stops afterwards.
DVR will not work if the microSD card in the display has less than 2 GB of capacity. The minimum
recommended capacity of the microSD card is 128 GB to have DVR work smoothly. Set the
Resolution to 1026x600 for a high video quality.
If the Begin and End Times have the same setting values, DVR will record without interruption.
VIDEO SNAPSHOT CAPTURE SETTINGS
Functions:
Storage type Resolution
Embedded flash 1920x1080 / 1280x720 / 640x 480,
memory as set
microSD card 1920x1080 / 1280x720 / 640x 480,
as set
. Touch and to open the DVR
Number of snapshots
100 snapshots max.
Depends on the microSD card capacity
14