ZAMEL VP-810BHD Handbuch Seite 30

ANSWERING AN ENTRANCE PANEL CALL
When a visitor presses the Call button on the entrance panel, all connected indoor
displays will sound the call chime at the same time with the INCOMING CALL
message on each display screen.
Touch the icon to answer the call. Touch the icon to output the calling
entrance panel camera feed on all other displays. terminates the call. If the call
is not answered by the time the call chime stops, the display will enter the standby
mode. Touch the icon to release the electric strike of the calling entrance
panel during the call. The display will show DOOR OPEN. Touch the icon to
open the gate. The display will show GATE OPEN. If another call is coming in
during your call, the display will show VISITOR AT DOOR 2. Touch the icon to
answer and switch to the second call.
Note: Touch the icon during an entrance call or an internal call
(display-to-display intercom mode) to mute your microphone. The display will show
MUTE . Touch again to unmute your microphone, which the display will
confirm with SPEAK .
Operating a gate requires the NC06 gate control module in the system.
VIDEO FEED MONITORING
With the display in standby, touch to monitor the video feed from the entrance
panel no. 1. Touch again to switch to the next video feed.
The CCTV camera video feeds can only be monitored this way if the Port 4 status is
Enabled (see Table SYSTEM SETTINGS, item 5). Touch to start a voice call
with the visitor at the entrance panel you are monitoring the video feed from. Touch
to unlock the door of the same entrance panel. Touch to unlock the
gate of the same entrance panel.
When monitoring the video feed from Door1/Door2/CCTV1/CCTV2, touch and hold
or swipe your finger left or right on the screen to change
the display setting from 16:9 to 4:3.
9