Hamamatsu Photonics Photo Dynamic Eye PDE C9830 Bedienungsanleitung Seite 17

1 Camera Cable
The cable to connect the Camera Unit with the Controller
2 Power Supply Cord
The cord to supply AC power to the PDE from the power socket
Connect the cord after confirming that the power switch of the PDE is turned OFF.
3 BNC‐BNC Cable
The cable to connect the PDE with an external video monitor or recorder
Use the attached BNC-RCA conversion connector if the input terminal of the external devices is the jack plug
type, and confirm that it is terminated by 75 Ω.
4 Remote Controller Cable [option]
The cable to connect the Remote Controller
The following parameters can be controlled by the Remote Controller (see page 6-24):
- Enhancements of contrast and brightness of the observed image
- Intensity of the observation light
Instruction Manual PDE
Version 1.30E
When the cables are connected, make sure that the power switch is in OFF
position.
Use the cord supplied with the PDE as accessory.
The video monitor and recorder are not included in the configurations of PDE.
Use devices that comply with EN60601-1-1.
Connecting Cables
Page 5-15