Ce Declaration Of Conformity - Walker 20HP25 Gebrauchs- Und Wartungshandbuch

CE DECLARATION OF CONFORMITY

Walker Filtration Ltd declare under our sole responsibility that this product is in
conformity with the following directive:Pressure Equipment Directive 97/23/EC.
Brian Walker
Name: .............................................................................
Executive Chairman
Position:...........................................................................
20 barg (300psig) High Pressure Compressed Air Aluminium Filter Housings
Housing Category / Assessment Route
Model SEP
20HP25
20HP37
20HP50
20HP75
20HP101
20HP150
20HP151
20HP200
20HP201
20HP300
20HP301
20HP302
50 barg (725psig) High Pressure Compressed Air Aluminium Filter Housings
Housing Category / Assessment Route
Model SEP
50HP25
50HP37
50HP50
50HP75
50HP101
50HP150
50HP151
50HP200
50HP201
100 HP Stainless Steel High Pressure Compressed Air Filter Housings
Housing Category / Assessment Route
Model SEP
100HP24
100HP49
100HP75
100HP100
100HP101
100HP150
100HP200
Notified body: Lloyds Register EMEA, 71 Fenchurch Street, London, EC3M 4BS
I/Module A II/Module D1
I/Module A II/Module D1
I/Module A II/Module D1
Signed: ............................................................................
February 2005
Date: ...............................................................................
350 HP Stainless Steel High Pressure Compressed Air Filter Housings
Housing Category / Assessment Route
Model SEP
350HP24
350HP26
350HP50
350HP75
350HP100
C50 HP Stainless Steel High Pressure Compressed Air Filter Housings
Housing Category / Assessment Route
Model SEP
C25
C37
C50
C75
C101
C150
C200
C201
The Pressure Equipment Directive 97/23/EC came into effect on 30
May 2002. Most pressure equipment and assemblies placed on the
market in the United Kingdom must comply with the Regulations.
Under the Regulations, pressure equipment and assemblies above
specified pressure/volume thresholds must:
• be safe;
• meet essential safety requirements covering design,
manufacture and testing;
• satisfy appropriate conformity assessment procedures; and
• carry the CE marking and other information.
Pressure equipment and assemblies below the specified pressure /
volume thresholds must:
• be safe;
• be designed and manufactured according to sound engineering
practice; and
• bear specified markings (but not the CE marking)
I/Module A II/Module D1
I/Module A II/Module D1