Peraqua 7300714 Installations- Und Benutzerhandbuch Seite 43

Size =MM
7300714
7300715
7300772
7300716
7500717
7500718
7500719
2.2.2. Heat pump installation.
 The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid; the bracket must be strong enough and anti-rust
treated;
 The heat pump needs a water pump (Supplied by the user). The recommended pump
specification-flux: refer to Technical Parameter, Max. lift ≥10m
 When the heat pump is running, there will be condensation water discharged from the
bottom, please pay attention to it. Please insert the drainage tube(accessory) into the
hole and clip it well, then connect a pipe to drain off the condensation water.
2.2.3. Wiring & protecting devices and cable specification
 Connect to appropriate power supply, the voltage should comply with the rated voltage
of the products.
 Well earth the heat pump.
 Wiring must be connected by a professional technician according to the circuit diagram.
 Set breaker or fuse according to the local code (leakage operating current ≤ 30mA).
 The layout of power cable and signal cable should be orderly and not affecting each
other.
A B
315 590
315 590
315 590
395 590
395 590
395 720
505 790
※ Above data is subject to modification without notice.
For installers and professionals
C D E
312 340 961
312 340 961
312 340 961
392 420 961
392 420 961
392 420 1092
496 530 1161
- 12 -
F G H
280 74 658
280 74 658
340 74 658
390 74 658
460 74 758
620 74 958
650 74 958