Hama 00020307 Bedienungsanleitung Seite 3

USER MANUAL
GB
Code scan for VCR, SAT, DVD, CD, TAPE, TUNER and AMP
To complete a code scan for VCR, SAT, DVD, CD, TAPE, TUNER or AMP, proceed as described
for a TV code scan. Complete above steps A to G, using keys
and / and / and
SHIFT CD SHIFT TAPE SHIFT
At step E,
for SAT and AMP, press the key;
for VCR, DVD, CD and TAPE, press the
for TUNER, press key .
2
Finding out what code number you are using
If you have programmed your remote control by means of the automatic code scan, or if you
have forgot the code you have stored then the following procedure will replay the codes being
used.
A. Press the key of your remote control for approx. 4 seconds until the LED flashes twice.
TV
B. Enter code , using the numerical keys. The LED flashes twice.
0 0 2
C. Press key and count the number of LED flashes. This number corresponds to the first
1
digit of the code.
D. Press key and count the number of LED flashes. This number corresponds to the
2
second digit of the code (if the digit is 0, the LED does not flash).
E. Press key and count the number of LED flashes. This number corresponds to the third
3
digit of the code (if the digit is 0, the LED does not flash).
F. Steps C, D and E can be repeated as often as necessary.
To read the currently used code for the control of a VCR, SAT, DVD/AUX, CD, TAPE, TUNER or
AMP device, proceed as described above for your TV SET. Complete steps A to F, pressing the
, , , , , or
VCR SAT DVD CD TAPE TUNER AMP
Write down the code number as indicated by the LED.
Programming for AUX devices
Depending on the model, you can use your universal remote control to operate a second TV
set, video recorder, satellite receiver/cable box, CD player, tape recorder, tuner or amplifier. To
program your remote control for a second device, proceed as follows:
1. Press the key of your remote control until the LED flashes twice.
AUX
2. Press
key for a second TV set,
TV
key for a second video recorder,
VCR
key for a second satellite receiver or cable box,
SAT
keys and for a second CD player,
SHIFT CD
keys and for a second tape recorder,
SHIFT TAPE
keys and for a second tuner,
SHIFT TUNER
keys and for a second amplifier.
SHIFT AMP
3. On the numerical keypad, enter a 3-digit code from the enclosed list.
4. The LED flashes twice, indicating that the code has been accepted.
/ or
VCR SAT DVD
or and respectively.
TUNER SHIFT AMP
key, and
key respectively.
4
GB
Special functions of your remote control
Brightness / Colour / Contrast / etc.
, or Adjusting brightness / colour / contrast / bass / tremble / balance at your TV set, using the
universal remote control:
1. Ensure that your remote control is set to TV (press
2. Press the
3. Within 5 seconds, press
for brightness,
1
for contrast,
3
for bass,
5
4. To adjust the settings use the
5. After 5 seconds, your remote control returns to standard mode for the selection of
channels.
Please write down the 3-digit codes of your devices for future reference. Depending on
the remote control model, you might have to reprogram me the universal control device
after a battery change.
TV
VCR
SAT/CABLE
DVD/AUX
CD
TAPE
TUNER
AMPLIFIER
USER MANUAL
key.
SHIFT
for colour,
2
for tremble,
4
for balance.
6
and keys.
VOL + VOL -
5
key).
TV