Phenomena Specific To Cmos Sensors; Built-In Speakers; Cleaning; Specifications - Sony IPELA PCS-L33 Kurzanleitung

Display pixels
Although the LCD display panel is made with high-
precision technology and has an effective picture element
ratio of over 99.99%, black dots (dead pixels) may appear
on the screen or pixels may become permanently lit (red,
blue, green, etc.) or unlit. The appearance of dead pixels
after extended periods of use is common among LCD
display panels. Be aware that such appearances do not
represent a malfunction.
Phenomena specific to CMOS
sensors
The following phenomena that may appear in images are
specific to CMOS (Complementary Metal Oxide
Semiconductor) sensors. They do not indicate malfunctions.
White flecks
Although the CMOS sensors are produced with high-
precision technologies, fine white flecks may be generated
on the screen in rare cases, caused by cosmic rays, etc.
This is related to the principle of CMOS sensors and is not
a malfunction.
The white flecks especially tend to be seen in the following
cases:
• when operating at a high environmental temperature
• when you have raised the gain (sensitivity)
Aliasing
When fine patterns, stripes, or lines are shot, they may
appear jagged or flicker.
Note on laser beams
Laser beams may damage a CMOS sensor. You are
cautioned that the surface of a CMOS sensor should not
be exposed to laser beam radiation in an environment
where a laser beam device is used.

Built-in speakers

The speakers generate magnetism. To avoid damaging the
data, keep magnetic tapes and disks away from the speakers.

Cleaning

• Before cleaning, disconnect the power cord from the AC
outlet.
• The LCD screen surface is finished with a special
coating. To remove dust from the screen surface, wipe
gently with a soft, dry cloth.
32

Specifications

• Do not use volatile solvents such as alcohol, benzene or
thinners as they may damage the surface finishes.
• When you use chemical cleaning cloth, observe the
instructions that come with it.
• Do not apply volatile solvents such as an insecticide to
the screen, or allow rubber or plastic objects to touch to
the screen for a long time, as they may damage the
surface finishes.
Specifications
PCS-TL33 Video Communication System
This unit is compliant with ITU-T Recommendations
H.323 and IETF SIP.
Motion picture
Operating bandwidth
64 kbps to 2048 kbps
Coding H.261/H.263/H.263+/H.263++/H.264
(ITU-T Recommendation)
MPEG4 Simple Profile
Picture elements
CIF: 352 pixels × 288 lines
QCIF: 176 pixels × 144 lines
Still Picture
Pixels 704 pixels × 576 lines
Encoding H.261 (ITU-T Recommendation) Annex.
D (4CIF)
H.263 (special format of this system)
Sound
Bandwidth 14 kHz (MPEG4 Audio)
7 kHz (G.722 compliant with ITU-T
Recommendation)
3.4 kHz (G.711/G.728/G.729 compliant
with ITU-T Recommendation)
Transmission rate
64 kbps, 96 kbps (MPEG4 Audio)
56 kbps, 64 kbps (G.711 compliant with
ITU-T Recommendation)
48 kbps, 56 kbps, 64 kbps (G.722
compliant with ITU-T
Recommendation)
16 kbps (G.728 compliant with ITU-T
Recommendation)
8 kbps (G.729 compliant with ITU-T
Recommendation)
Network
Multiplexing Video, audio, data
Frame format H.225.0 (compliant with ITU-T
Recommendation)
Interface LAN (100BASE-TX/10BASE-T)