Maintenance Cleaning; Sensor Calibration/Replacement; Storage - RIDGID micro CD-100 Bedienungsanleitung

micro CD-100 Combustible Gas Detector
and OFF. The gas detector will beep once when the Audible
Alert is turned ON and OFF. Press and release the Vibration
Alert button to turn it ON and OFF. The gas detector will vibrate
twice when turning the Vibration Alert ON and vibrate once
when turning the Vibration Alert OFF.
6. Enter the area to be monitored. Pay close attention to the gas
level indicators (see Table 1). As gas levels increase, more red
level lights will come on and the frequency of the Audible Alert
beeping and the Vibration Alert vibration will increase. See
Table 1 for information on methane concentration levels and
gas detector feedback.
Table 1 – Gas Detector Feedback For Methane Concentration
Levels
Low Sensitivity High Sensitivity
White Light ON Yellow Light ON L1 L2 L3 L4 L5
< 400 ppm < 40 ppm
400...800 ppm 40...80 ppm
800...1600 ppm 80...160 ppm
1600...3200 ppm 160...320 ppm
3200...6400 ppm 320...640 ppm
> 6400 ppm > 640 ppm
When the gas detector is turned ON it is in whatever sensitiv-
* Gas Concentration levels may differ depending on the specific gas detected
ity state it was last in. In the low sensitivity setting, the lowest
concentration of methane detected is 400 ppm. Switch the sen-
sitivity to the high setting by pressing the high sensitivity button
(H). This will be indicated by the yellow light in the bottom right
of the display. In the high sensitivity setting, the gas detector is
ten times more sensitive, with the lowest concentration of
methane detected at 40 ppm. Sensitivity can be changed at
any time by pressing the High Sensitivity (H) or Low Sensitiv-
ity (L) buttons.
10
Level Lights Audible Alert
Beeping
OFF OFF OFF OFF OFF 1 cyc/sec
ON OFF OFF OFF OFF 1.02 cyc/sec
ON ON OFF OFF OFF 1.2 cyc/sec
ON ON ON OFF OFF 1.65 cyc/sec
ON ON ON ON OFF 3.25 cyc/sec
ON ON ON ON ON 6.25 cyc/sec
If locating a leak, use the gas detector to find areas of lower
gas concentration and follow back to the source. In a piping
system, trace the system, stopping at the joints to monitor the
gas levels.
7. When gas detection is complete, turn the micro CD-100 OFF
by pressing the ON/OFF button.
Maintenance
Do not immerse the micro CD-100 in water. Wipe off dirt with a
Cleaning
damp soft cloth. Do not use aggressive cleaning agents or solu-
tions. Treat the instrument as you would a telescope or camera.
The micro CD-100 requires no calibration other than that done at

Sensor Calibration/Replacement

regular start up. If the sensor should fail, the sensor (Catalog Part
#31948) can be replaced by a RIDGID Independent Authorized
Service Center.

Storage

The RIDGID micro CD-100 Combustible Gas Detector must be
stored in a dry secure area between -10°C (14°F) and 60°C
(158°F).
Store the tool in a locked area out of the reach of children and peo-
ple unfamiliar with the micro CD-100.
Remove the batteries before any long period of storage or shipping
to avoid battery leakage.
Ridge Tool Company