Auto Standby Function; Select Modes - HAISER HSR 120 BT Gebrauchsanweisung

Auto Standby Function

The HAISER sound system applies to the strict European rules for electricity saving (ERP II) and
automatically switches off if there is no source signal for 15 minutes or if the signal is too weak.
For special uses this function may be temporarily disabled.
Disable Auto Standby Function:
• Hold VOL+ in Standby Mode until the red Standby LED slowly flashes one time.
Enable Auto Standby Function:
• Hold VOL+ in Standby Mode until the red Standby LED rapidly flashes three times.
Power-Boot Function
The sound system switches to standby mode after the power supply has been interrupted.
However, you can also configure the sound system to automatically switch to the last operating
mode used by bypassing the standby mode. This is helpful when using switchable socket strips.
Enable power-boot function:
• In standby mode, press and hold the
flashes slowly one time.
Disable power-boot function:
• In standby mode, press and hold the
flashes rapidly three times.

Select Modes

Press the /SOURCE button repeatedly on the unit to switch between AUX and BLUE-
TOOTH modes.
• In AUX mode: Light up Green.
• In Bluetooth mode: Light up Blue.
/SOURCE button until the red standby LED
/SOURCE button until the red standby LED
27