DeWalt DW085 Bersetzt Von Den Originalanweisungen Seite 55

Troubleshooting
THE LASER DOES NOT TURN ON
• Make sure batteries are installed according to (+), (-) markings on
battery door.
• Make sure the batteries are in proper working condition. If in doubt, try
installing new batteries.
• Make sure that the battery contacts are clean and free of rust or
corrosion. Be sure to keep the laser level dry and use only new, high-
quality batteries to reduce the chance of battery leakage.
• If the laser has been stored in extremely hot temperatures, allow it to
cool.
THE LASER BEAMS FLASH (FIG. 4)
The DW085 laser level has been designed to self-level up to 4° in all
directions when positioned as shown in Figure 4. If the laser is tilted so
much that internal mechanism cannot plumb itself, it will flash the laser—
the tilt range has been exceeded. THE FLASHING BEAMS CREATED BY
THE LASER ARE NOT LEVEL OR PLUMB AND SHOULD NOT BE USED
FOR DETERMINING OR MARKING LEVEL OR PLUMB. Try repositioning
the laser on a more level surface.
THE LASER BEAMS WILL NOT STOP MOVING
The DW085 is a precision instrument. Therefore, if it is not positioned on a
stable (and motionless) surface, the tool will continue to try to find plumb.
If the beam will not stop moving, try placing the tool on a more stable
surface. Also, try to make sure that the surface is relatively flat, so that the
laser is stable.
Cleaning
• Remove the batteries before cleaning the tool.
• Keep the ventilation slots clear and regularly clean the housing with a
soft cloth.
• When necessary, clean the lens using a soft cloth or a cotton bud
soaked in alcohol. Do not use any other cleaning agents.
ENGLISH
53