Stryker 6254 Bedienungsanleitung Seite 12

I I n n s s t t r r u u c c t t i i o o n n s s
These instructions are printed on the backrest of the Evacuation Chair.
To use the evacuation chair:
1. Stand behind the chair and pull the backrest and extension handle apart to unfold the chair.
W W A A R R N N I I N N G G - - Always make sure that the chair is locked in the unfolded position before use. An unlocked chair may fold
during use.
2. Pull the red release cable with one hand and pull up on the control handle with the other hand to extend the upper
control handle.
3. Squeeze the red track release bar against the black crosstube. Relax your grip on the release bar and forcefully pull the
S S t t a a i i r r - - T T R R E E A A D D system to the fully extended position until both sides lock securely. Always make sure that both sides the
S S t t a a i i r r - - T T R R E E A A D D system are locked by trying to fold it back up.
C C A A U U T T I I O O N N - - Always release the red track release bar before you click the S S t t a a i i r r - - T T R R E E A A D D system into the locked position.
Try to fold the chair before you descend the stairs to make sure that the S S t t a a i i r r - - T T R R E E A A D D system is locked.
4. Tilt the chair back just far enough to allow the S S t t a a i i r r - - T T R R E E A A D D system to contact the floor.
5. Maintaining the angle, guide the chair over the edge of the stairs, allowing the S S t t a a i i r r - - T T R R E E A A D D system to connect with the
first step.
6. Glide down the stairs until the treads are level across the edges of two or three steps.
EN 8 6254-109-005 Rev B.3