Trouble Shooting; How To Change The Bulb; If Something Does Not Work - Zanussi znb 34nc Gebrauchsanleitung

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the cover (1), press the rear
hook (2) and at the same time slide the cover in the direc-
tion indicated by arrow (3). So the bulb can be replaced.
(Bulb type: 230-240 V, 15 W, E 14 thread)
After changing the bulb replace the cover, snap it in place,
screw back the screw and apply voltage to the appliance.

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, this goes together with the operation
of the appliance.
We draw it to your attention again that the appli-
ance operates discontinuously, so the stopping of
compressor does not mean being no-current. That is why
you must not touch the electrical parts of the appliance
before breaking the circuit.
G G B B
51