Installation - Atlas Filtri OASIS DPRO Installationsanweisungen

➥
At the end of the OASIS device working life and relevant cartridges, membranes and UV lamps, discard according to
current local law.

2. INSTALLATION

2.1 Preface
➥
Assembly and installation must be performed by qualified personnel according to current local regulations. Before
performing any operation, carefully read the instructions in this manual. Keep the manual and protect it against anything
that could compromise its legibility.
2.2 Main components
1 DP TRIO head for housings
for filter cartridges
2 DP TRIO housing bowls
for filter cartridges
3 RO VESSEL housing
for osmosis membrane
4 Storage tank
5 AIC activated carbon post-filter
6 UV lamp (UV models)
7 Booster pump (PUMP models)
8 AIM re-mineralising post-filter
2.3 Connections diagram (fig. 1 and fig. 2)
➥
The percentage of dissolved salt and other rejected elements depends on the water quality, temperature, pressure and
total amount of dissolved salts and varies according to the type of salt or elements.
Processing particularly turbid water or with many impurities can clog filters and/or membranes with the consequent loss
of water flow.
Sewage water, sea water or water with chemical, physical and bacteriological conditions that can not be subject to
Reverse Osmosis (industrial water or chemical processing waste) cannot be processed.
Ultraviolet ray lamps are hazardous to the eyes, avoid direct exposure.
2.4 Technical specifications (tab. A)
➥
Product use in working conditions other than the TECHNICAL SPECIFICATIONS is considered IMPROPER USE.
The manufacturer cannot be held liable for any damages caused by improper use, by failure to observe what indicated
in this manual, by repairs not performed by professionally qualified personnel or due to changes and alterations to the
original device functions.
3
7
1
2
8
6
5
4
|
5 OASIS DP RO