Clock/Timer Selection; Set Timer - TechGrow Ballast Basic Micro Anleitung

Date 01-01-2019
Time 15:24:00 ok
Turn the PTK to cancel and adjust or press the PTK to
confirm. You return to the main menu.

5.2 Clock/Timer selection

You are in the main menu. Select "Timer mode" and
press the PTK.
Set clock
=> Timer mode
Set timer mode
24 hour
If you opt for 24 hour, press the PTK.
On at 00:00
Off at 00:00
Set the desired switching times. Press the PTK to return
to the main screen.
ATTENTION: After saving these settings, the Ballast
Basic Micro always starts with the "On" period.
The main screen displays:
24-03 19:56:33
- 05:00 + 18:30
The switching times are displayed with + (on) and – (off).
You can also opt for the asynchronous timer:
Set timer mode
Asynchronous
Press the PTK to confirm. Set the desired switching times
(on for/off for).
____________________________________________________________________________________________________________________________
TechGrow | InnovativeGrowingSolutions
Press the PTK to confirm. You enter the main screen.
ATTENTION: After saving these settings, the Ballast
Basic Micro always starts with the "On" period.
24-03 02:30:24
12:30 12:35
24-03 12:31:15
12:35 22:35
24-03 12:35:01
22:35 22:40
In the previous example the cycle lasts 10 hours and 5
minutes: the relays alternately go on for 10 hours and
off for 5 minutes.
The controller starts with the "on"-period. The relays will
be switched off after 10 hours, at 12:30. The relays will
be off for 5 minutes until 12:35. At 12:35 the relays will
be on for 10 hours again, until 22:35, and so on.

5.3 Set timer

You are in the main menu. (If necessary, reboot the
Ballast Basic Micro to get here.)
Select "Set timer" and press the PTK.
Timer mode
=> Set timer
24-hour mode:
On at 00:00
Off at 00:00
Asynchronous mode:
On for 00:00
Off for 00:00
12