Herunterladen Inhalt Inhalt Diese Seite drucken

Lifting; Transport; Regulations For Safe Use And The Prevention Of Accidents - Checchi & Magli UNITRIUM Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für UNITRIUM:
Inhaltsverzeichnis

Werbung

6.0 - LIFTING

6.1 - Check that the lifting gear, hooks, ropes, chains, etc., are of suffi cient capacity
for the task (see weight indicated on machine data plate and in the weights and measures
table).
6.2 - Fix hooks, ropes, chains, etc. in the three positions shown in (fi g.3) and marked by the graphic
symbol 'HOOK'.
6.3 - Operate the lifting system slowly and before lifting defi nitively, make certain that no deviation
occurs and that there are no members of the public in the work area.
6.4 - Keep at a safe distance and do not for any reason enter areas subject to the risk of accidental
falling of the machine.

7.0 - TRANSPORT

Check that the vehicle to be used is suitable in terms of capacity, size and any other respect stipulated
in the highway code.
Position the machine in such a way that it does not protrude beyond the profi le of the vehicle, and fi x it
adequately with ropes or other means so as to prevent uncontrolled movements.

8.0 - REGULATIONS FOR SAFE USE AND THE PREVENTION OF ACCIDENTS

8.1 - Read all the instructions before using the machine, especially those which rela-
te to safeguarding against physical injury. The Manufacturer accepts no responsibility
for any damage arising from improper use of the machine or failure to observe these instructions.
It is the duty of the user to inform employees and other personnel of the directions set out in this
document (this is a legal requirement).
8.2 - Pay attention to the danger symbols shown in this manual and on the machine.
8.3 - Adjustment, maintenance or work of any kind on the machine must be carried out only with
the engine OFF, the machine resting on the ground, and the tractor locked (parking brake
engaged).
8.4 - Couple the machine only to a tractor of adequate power (see technical bulletin referring to the
model in use), and with a lift unit which complies with standards specifi cally for tractors.
Adhere to the maximum stipulated weight on the axle, and the total mobile weight.
8.5 - When coupling and uncoupling the machine, pay maximum attention so as to avoid the risk
of crushing.
8.6 - It is strictly forbidden for the tractor to be driven by inexpert personnel or personnel not in
possession of a driving licence or in poor health.
8.7 - Never leave the operator position when the tractor is running.
Before leaving the tractor, lower the lift unit, stop the engine, operate the parking brake and remove
the ignition key from the control panel.
8.8 - Remember that the road-holding, steering and braking are affected by the presence of a
carried or towed machine.
8.9 - When driving on the road it is necessary to abide by the highway code of the country in
question.
8.10 - When transporting by road, with the machine lifted, put the hydraulic lift unit control lever in
the locked position.
8.11 - The operators must take position on their respective seats and place their feet on the foot-
rests (fi g. 4.A) only when the tractor is stationary and chocked and the machine is on the
ground.
It is strictly forbidden to travel from one work area to another or on the road with the lift unit
raised and operators on board. It is forbidden to alight if the machine is moving or not positioned
on the ground.
8.12 - The moving parts (wheels - chains - distributors etc.) are protected by appropriate guards,
and where this is not reasonably possible, suffi cient space has been allowed so as to prevent the
risk of crushing. Upon no account wear loose clothing, which may become trapped in the parts
described above during operation, and in any event, pay maximum attention while working, as
moving parts of any machine are inherently dangerous.
8.13 - Do not remove the safety and protection devices which have been installed. If they are
removed for the purpose of making adjustments or carrying out maintenance, ensure that they are
refi tted in their correct place.
8.14 - Check the effi ciency of the protection devices periodically and renew them when neces-
sary, using only original spare parts, which can be supplied by the Manufacturer or its authorized
dealers.
UNITRIUM
21

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis