Telcoma RB2-Serie Gebrauchs- Und Programmierungsanleitung Seite 30

GB
Code self-learning
- On the receiver briefly press the pushbutton P that corresponds to the output on
which the transmitter is to be activated.
- LED L blinks 5 times.
- During the blinks, press the key of the code to be memorized on the transmitter.
The LED on the receiver gives a longer blink to confirm that it has been
memorized correctly.
Repeat the self-learning operation for any other transmitters.
Code self-learning for advanced functions
There are three different learning procedures, each of which assigns a different
operating mode:
1) PULSE mode: the output is only active during radio transmission.
- Press button P (fig.1, 2 and 3) quickly on the receiver.
- LED L blinks 5 times.
- During the blinks, press the key of the code to be memorized on the transmitter.
The LED on the receiver gives a longer blink to confirm that it has been
memorized correctly.
Repeat the self-learning operation for any other transmitters.
2)STEP/STEP mode; the first transmission activates the output (ON) and the next
one deactivates it (OFF).
- During programming, press key P (fig.1, 2 and 3) twice.
- LED L will blink twice, 5 times.
-During the blinks, press the key of the code to be memorized on the transmitter.
- The LED remains on steadily for a few moments to confirm that the learning
procedure has been successful.
If the power supply fails with the output activated, it is deactivated.
3)TIMER MODE: after release of the transmission button, the output remains on
for 30".
- During programming, press key P (fig.1, 2 and 3) three times.
- LED L will emit 5 sets of 3 blinks.
- LED L remains on steadily for a few moments to confirm that the learning
procedure has been successful. The output relating to key P is now operational in
timer mode.
With the NOIRE and FM400 software and the relative programmers, the timer
time setting can be programmed from 1 to 255 seconds.
30