Micro-Star International G52-73091X2 Bedienungsanleitung Seite 13

IDE Connector: IDE1
The mainboard has dual Ultra
Bus Master, and Ultra DMA 66/100/133 function. You can connect up to two hard disk
drives, CD-ROM, 120MB Floppy and other devices.
The first hard drive should always be connected to ID
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly.
MSI Reminds You...
If you install two hard disks on one cable, you must configure the second drive to Slave mode by
setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
Serial ATAII Connectors: SATA1~2
SATA 1, 2 are dual high-speed Serial ATA interf
generation serial ATA data rates of 300 MB/s. All connectors are fully complian
with Serial ATA 2.0 specifications. Each Serial ATAII connector can connect to 1 h rd disk device.
MSI Reminds You...
Please do not fold the serial ATA cable in a 90-degree angle, which will cause the loss of data
during transmission.
CD In Connector: JCD1
The connector is for CD-ROM au
Chassis Intrusion Switch Connector: JCI1
This connector is connected to a 2-pin chassis switch.
Fan Power Connectors: CPUFAN1/SYSFAN1
The 4-pin CPUFAN1 (processor fan) and 3-pin SYSFAN1 (sy
fan) support system cooling fan with +12V. When connecting the
wire to the connectors, always take note that the red wire is the
positive and should be connected to the +12V, the black wire is G
to GND. If the mainboard has a System Hardware Monitor chipset on-board, you must use a
specially designed fan with speed sensor to take advantage of the CPU fan control.
MSI Reminds You...
Always consult the vendors for the proper CPU cooling fan.
Front Panel Connectors: JFP1, JFP2
The mainboard provides a front panel connector fo
connection to the front panel switches and LEDs. JFP1 is
compliant with Intel
DMA 66/100/133 controller that provides PIO mode 0~4,
dio connector.
®
Front Panel I/O Connectivity Design G
E1. IDE1 can connect a Master
ace ports. Each supports 2nd
R
GND
CINTRU
1
GND
2
stem
round and should be connected
r electrical
uide.
7
t
a
L
GND
+12V
Sensor
Control
10
Speaker
Power
2 8
Switch
1 7
Power
LED
Power LED
JFP2
JFP1
GND
+12V
Sensor
9
Reset
Switch
HDD
LED
2
1