Two Treatment Modes: Stamp & Flash And Slide & Flash - Philips Lumea SC2005 Bedienungsanleitung

3 Press the device 'irmly onto your skin to ensure proper skin contact.
The 'ready to 'lash' li'ht on the back o' the device li'hts up 'reen to
indicate that you can proceed with the treatment.
4 Press the 'lash button to release a 'lash. You should 'eel a warm
sensation because o' the 'lash.
Note: The light produced by the device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
5 Place it on the next area to be treated. A'ter each 'lash, it takes up to 3.5
seconds until the device is ready to 'lash a'ain. You can release a 'lash
when the 'ready to 'lash' li'ht li'hts up a'ain.
6 To make sure that you have treated all areas, release the 'lashes close to
each other. However, make sure you 'lash the same area only once.
Flashin' the same area twice doesn't improve the e''ectiveness o' the
treatment, but increases the risk o' skin reactions
Two treatment modes: Stamp & Flash and Slide & Flash
Your Philips Lumea has two treatment modes 'or more convenient use on
di''erent body areas:
- The Stamp & Flash mode is ideal to treat small or curvy areas like knees
and underarms. Simply press and release the 'lash button to release a
sin'le 'lash.
- The Slide & Flash mode o''ers convenient use on lar'er areas like le's.
Keep the 'lash button pressed while you slide the device over your
skin to release several 'lashes in a row.
English
13