Inhaltsverzeichnis
Werbung
GB
The blade pitch control knob is at easy reach of the operator. The pitch adjustment has an unlimited pitch variation and this can
adjustment can be changed to suit accordingly while the machine is in operation. When transporting the trowel on a truck, always
GB
For transportation of the machine use lifting eye. Alternatively to lift the machine, use an aid equipment through the stationary ring, which
can carry the weight of the machine ,with a carrying pipe on the back past of handle.
GB
Problem
Cause
Engine will not start.
No fuel getting to engine.
Engine switched off.
Spark plug fouled.
Engine cold.
Cutout switch wire
Leaving Swirls in
Main Shaft damaged.
concrete, Rolling
Spider Plate arms bent.
Concrete or Bouncing.
Blades are unevenly adjusted.
Blades are all different sizes.
Blades are worn.
GB
Gearbox
Machine Cleaning
to remove. To clean it use an old brush or hand brush.
Changing of Blades
Be careful when changing old blades with new. Due to the way the blades wear, the old blades become very sharp, like a knife
blade. As a safety precaution very heavy-duty gloves during this operation to prevent the hands being cut. Remove bolts and lock
of the trowel, be sure trowelling edge of the blade is behind trowel arm. Install bolts and lock washers on each trowel arm and
fasten securely.
Tightening the V-Belts
the motor backward. Checking the V belt tightness, do the same operations. Until tightness of V belt is desired value, screw the
Blade Adjustment
Transportation
Troubleshooting Guide
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean, check and reset plug gap.
Close choke.
Reconnect disconnected wire.
Check and replace as necessary.
Replace as necessary.
Check and adjust as necessary.
Replace, ensuring all blades are the same size.
Replace blades.
Servicing
10
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
