Connection Diagram - Velleman NVR1 Schnelleinstieg

7. To install a second hard disk, find the supplied hard disk brackets in the package, and fix them to the NVR
base.
8. With the PCB side facing up, connect the hard disk to the power connector and data connector.
9. Place the hard disk in the brackets and fasten it with the supplied screws, two for each side.
10. Replace the top cover and fasten the screws.

7. Connection Diagram

Note: To ensure that automatic configuration works well, connect and switch on the IP cameras first. Only then
switch on the NVR.
You can connect up to 6 IP cameras.
Refer to the illustrations on page 2 of this manual.
Remote connection: use this method for Push
Video IP cameras and IP cameras connected via
the internet.
1. Enter the IP address and the access information in
the NVR.
2. Wait until you see the images on the monitor.
C Push Video camera
D internet camera
E 8P8C (RJ45) network cable
F modem
G hub/switch
8. Information and Panels on the Monitor
Refer to the illustrations on page 2 of this manual.
15 NVR status
key lock
channel lock
USB flash drive / device connected
V. 01 – 23/03/2012
A
NVR1
Local connection: use this method for ETS
cameras.
1. Connect the camera to a hub/switch.
2. Wait until the camera is configured automatically
and the images appear on the monitor.
H router
I mouse
J NVR back panel
K monitor supporting high-definition video
L 19VDC power supply adapter
key unlock
channel unlock
no USB device connected
5
B
©Velleman nv