Quick Operation - Velleman NVR1 Schnelleinstieg

IP
10.1.1.12
10.1.1.13
10.1.2.14
10.1.1.15
10.1.1.16
10.1.1.17
2. Select an IP address that is not used (UNUSED), and click SETUP.
NETWORK TYPE
IP
PORT
USER NAME
PASSWORD
NETMASK
GATEWAY
PRIMARY DNS
3. Select STATIC in NETWORK TYPE, and change the IP address to 10.1.1.xx (xx ranges from 11 ~ 253).
4. Click APPLY and EXIT to save your changes.
5. Wait until the NVR detects the IP camera and displays images.
11.

Quick Operation

Switching on/off and Rebooting
To power off or reboot the NVR, you can:
• Use the power switch on the NVR rear panel, or
• In the quick operation panel [18], click
Viewing a Channel in Full-Screen Mode
To view a channel in full screen mode, you can:
• Click directly on the channel image to see that channel in full screen mode. Double-click the image to
restore the 6-channel overview.
• In the quick operation panel [18], click
want to display in full screen mode. Click
V. 01 – 23/03/2012
NVR1
IP SEARCH
PORT MAC
88 00:0e:53:e5:9a:f1
88 00:0e:53:a6:91:18
88 00:0e:53:a5:9f:a2
88 00:0e:53:e1:4e:k5
88 00:0e:53:s5:3e:h6
88 00:0e:53:e6:4b:26
SETUP
and then click
. On the control panel that appears, select the channel you
to restore the 6-channel overview.
STATUS
BE CONNECTED ON CH1
BE CONNECTED ON CH2
UNUSE
BE CONNECTED ON CH3
BE CONNECTED ON CH4
BE CONNECTED ON CH5
CONNECT SETUP
STATIC
10.1.1.14
88
admin
*****
255.0.0.0
10.1.1.10
168.95.1.1
APPLY EXIT
(power off) or
10
EXIT
(reboot).
©Velleman nv